Aquinity² P10 Ultra Pure Water System

• Aquinity² models produce ultra pure water directly from tap water.
• The Aquinity² P10 ultra pure water system is equipped with a reverse osmosis (RO) module to produce deionised water directly into an integrated 10l tank.
• In the next step Type I grade water is produced with a polisher cartridge.
• The Aquinity² water purification system is available in different configurations (Reagent & Analytical) to meet the specific requirements of ultra pure water for different applications.
• Analytical is a version with UV lamp for low TOC value. 
• Life Science grade water with low endotoxin can be generated with a special final filter. 
• An optional integrated TOC sensor allows the user to monitor the TOC content permanentely online. 
• Besides that the Aquinity² can be configure as bench top or bench-integrated system, where the control panel will mounted on the wall.

Resistivity/Conductivity
18.2 MOhm x cm | 0.055 µS/cm; Type I
Production Rate
max. 8 L/h
Total Organic Carbon (TOC)
< 10 ppb (Reagent)
< 3 ppb (Analytical)

The scheme shows an Aquinity P10 Analytical.

To save valuable benchtop space the system can be ordered as BI configuration. The system will be installed underneath the work bench and only the display and dispenser are mounted on the wall.

To save valuable benchtop space the system can be ordered as wall mounted configuration. the whole system can be mounted on the wall with inclined display.

Validation documents for water purification systems.

The TOC monitoring during production and intermittent measurements during non-use periods allows to check the organic content in water continuously. The TOC value is measured between 1 and 999 ppb and can be shown in the display to monitor organic impurities.

Our dispenser allows the volumetric controlled dispensing of water with an increment of 0.1 L and a tap volume from 0.1 to 99 L. The system prevents overflow of containers and allows to dispense water without supervising.

To be integrated into an ultra pure water system with a max, flow rate of 2 L/min. Point of use dispense arm with integrated control unit. Two joint to move it horizontally and vertically allowing to fill containers up to 55 cm height. Volumetric dosing of ultra pure water allows filling of containers without the attention of user, dosing eange 0.1 – 99 L, variable input and storage of values, after volume has been dispensed system goes back to standby.